Microlift Rod Pumping Units

Microlift produces rod pumping units for gas wells and oil wells. Exclusive energy recovery mode technology uses as little as one-half the electricity, LP or natural gas as typical beam pumping units operating under the same conditions.

Additional features include

Down stroke energy recuperation and balancing assures high efficiency and lower operating cost regardless of fluctuating well fluid levels.

  • Complete stroke control, for efficient pumping of both vertical and deviated well bores
  • Gauges well loads at start-up and self-adjusts continuously to changes in well fluid levels

No electricity on site?

Combustionless engines use existing gas pressure and require no air emissions permit.


Need a quote?

Request one from us by clicking on the link below!

Request a Quote

Stren SC2000 XPR

SC2000 XPR completion screens provide a clean, sand-free wellbore for increased production flow and pump intake protection. Meeting or exceeding all other industry products, our inflow surface area ranges to 60 percent + compared with wire-wrapped screens or sand pre-packs at 3 to 9 percent.



“If you let sand get into your pump, you have a fight on your hands.”


Learn More

Microlift™pumping units for producing gas wells

Pumping water off a gas well relieves back-pressure on the reservoir and generally increases daily production.

Microlift technology delivers high performance and low cost to producing gas wells through second generation, oilfield tough pumping unit technology for gas well dewatering.

Pump spaceout by the push of a button

Finger-tip controls eliminate the concern of fall or injury moving polish rod clamps. Control of plunger position (rod pump compression ratio) for gas well dewatering and pumping light crude oils (condensate) is CRITICAL to efficient pumping and avoiding lost production due to gas locking of pump. Self-balancing Microlift pumping units gauge well loads at start-up and self adjust continuously to changes in well fluid level. These units are portable and easily installed on existing wellhead by a standard workover rig, ideal for gas well unloading, eliminates swabbing, and maintains consistent production.


Microlift™ pumping units for producing oil wells

Microlift technology delivers high performance and low cost to rod-lifted oil wells through second generation, oilfield tough pumping unit technology. Utilizing Microlift energy recovery mode technology, these units typically use as little as one-half the electricity, LP or natural gas as typical beam pumping units.

Pump spaceout by the push of a button

Finger-tip controls eliminate the concern of fall or injury moving polish rod clamps. Down stroke energy recuperation and balancing assures high efficiency and lower operating cost regardless of fluctuating well fluid levels. Change SPM from your office computer screen with a mouse click.


Microlift Brochures

Click the thumbnail to view our Microlift Rod Pumping Brochure

Click the thumbnail to view our Microlift Flyer